Honda CR-V (3rd Gen.) (2006-2010) Torque Spec Settings
Below you'll find the tightening torques for the Honda CR-V (3rd Gen.) in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Honda CR-V (3rd Gen.)
Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Oil filter | Oil filter | 12 | 9 |
|
||
Intake manifold | Intake manifold | 22 | 16 |
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2006 - 2010
- Generation: 3
- Type of van: car
- Model variant: Base
All Torque Settings in Tables
engine torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Oil pan | Oil pan | 12 | 9 |
|
||
Oil filter | Oil filter | 12 | 9 |
|
||
Oil filter | Oil filter Cover | 12 | 9 | M6 |
|
|
Oil filter | Oil filter Cover | 22 | 16 | M8 |
|
|
Oil pressure switch | Oil pressure switch | 18 | 13 |
|
||
Oil filter | Oil filter feed pipe | 49 | 36 |
|
||
Oil pump | Oil pump sprocket | 12 | 9 | M6 |
|
|
Oil pump | Oil pump sprocket | 27 | 20 | M8 |
|
|
Oil pump | Oil pump sprocket | 44 | 32 | M10 |
|
|
Oil pump | Oil pump mounting bolt | 22 | 16 | M8 |
|
|
Oil pump | Oil pump mounting bolt | 44 | 32 | M10 |
|
|
Cylinder head | Cylinder head | 18 | 13 |
|
||
Intake manifold | Intake manifold | 22 | 16 |
|
||
Intake manifold | Intake manifold Cover | 12 | 9 |
|
||
Throttle body | Throttle body | 4 | 3 |
|
||
Engine block | Engine block | 29 | 21 | Bearing cap |
|
|
Engine block | Engine block | 22 | 16 | M8 bolt |
|
|
Engine block | Engine oil gallery cap | 41 | 30 |
|
||
Engine mounts | Engine mounts | 44 | 32 | Side engine mount bracket |
|
|
Engine mounts | Engine mounts | 81 | 60 | Lower rod bracket |
|
|
Engine mounts | Engine mounts | 44 | 32 | Compression bracket |
|
|
Engine mounts | Engine mounts | 74 | 55 | M12 |
|
|
Engine mounts | Engine mounts | 22 | 16 | M8 |
|
|
Engine mounts | Engine mounts | 103 | 76 | M14 |
|
|
Sensor | CMP Sensor | 39 | 29 |
|
||
Sensor | ETC Sensor | 12 | 9 |
|
||
Sensor | A/F Sensor | 44 | 32 |
|
||
Sensor | CKP Sensor | 12 | 9 |
|
||
Sensor | MAP Sensor | 3 | 2 |
|
||
Sensor | Knock Sensor | 3 | 2 |
|
||
Alternator | Alternator | 3 | 2 |
|
||
Alternator | Alternator housing | 110 | 81 |
|
||
Starter | Starter | 9 | 7 |
|
||
Battery | Ignition coil | 10 | 7 | Minimum |
|
|
Battery | Ignition coil | 12 | 9 | Maximum |
|
|
Camshaft | Camshaft holder | 22 | 16 |
|
||
Crankshaft | Crankshaft main bearing | 29 | 21 |
|
||
Water pump | Water pump | 12 | 9 |
|
||
Radiator | Thermostat | 10 | 7 |
|
||
Radiator | Fan shroud | 7 | 5 |
|
||
Air conditioning | Compressor | 10 | 7 | M6 |
|
|
Air conditioning | Compressor | 22 | 16 | M8 |
|
|
Air conditioning | Compressor | 59 | 44 | M10 |
|
|
Belt tensioner/Timing chains | Drive belt auto tensioner | 56 | 41 | Tensioner Pulley (B) |
|
|
Belt tensioner/Timing chains | Drive belt auto tensioner | 22 | 16 | Tensioner Pulley (A) |
|
|
PCM | PCM | 10 | 7 |
|
||
Rocker arm | Rocker arm | 12 | 9 |
|
||
Rocker arm | Rocker arm Cover | 22 | 16 |
|
drivetrain torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Differential | Differential carrier | 3 | 2 | Minimum |
|
|
Differential | Differential carrier | 4 | 3 | Maximum |
|
|
Clutch pressure plate | Clutch pressure control | 12 | 9 |
|
||
Flywheel/Flex plate | Drive plate | 74 | 55 |
|
||
Transmission fluid pan | Transmission fluid filter (ATF) | 12 | 9 |
|
||
Transmission fluid pan | Transmission drain plug | 49 | 36 |
|
||
Transmission mount/case | Transmission mount | 54 | 40 | M12 |
|
|
Transmission mount/case | Heat shield | 10 | 7 |
|
||
Transfer | Transfer | 32 | 24 | M8 |
|
|
Transfer | Transfer | 44 | 32 | M10 |
|
|
Transfer | Shif lever mounting bracket | 22 | 16 |
|
steering torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
---|
exhaust torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Exhaust manifold | Exhaust manifold | 44 | 32 |
|
||
Exhaust manifold | Exhaust manifold Cover | 22 | 16 |
|
||
EGR | EGR | 22 | 16 |
|
||
Muffler | Muffler | 22 | 16 |
|
||
Catalytic converter | Catalytic converter | 24 | 18 | M8 |
|
|
Catalytic converter | Catalytic converter | 33 | 24 | M10 |
|
brakes torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Brake booster | Brake booster | 12 | 9 |
|
||
Parking brake | Parking brake | 294 | 217 |
|
suspension torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
---|---|---|---|---|---|---|
Ball joint | Ball joint | 59 | 44 |
|
general torque settings
Save to email ✉️Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
---|
Did you find the answer to your specific question?
👍 3 👎 41