Citroën Jumpy 3 (2016-on) Torque Spec Settings
Photo © Vauxford, CC BY-SA 4.0, via Wikimedia Commons
Below you'll find the tightening torques for the Citroën Jumpy 3 in both Nm and ft/lbs. The first table contains the most-used torque settings. The second table contains all torque spec values I could find.
Most-Used Torque Settings for Jumpy 3
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Source |
|---|---|---|---|---|---|
| Engine oil drain plug | 34 | 25 |
 |
||
| Oil filter return pipe | 8 | 6 |
|
||
| Front brake caliper support bolts | 190 | 140 |
|
||
| Rear brake caliper support bolts | 108 | 80 |
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2016 - present
- Generation: 3
- Model variant: Base
- Also known as:
All Torque Settings in Tables
General torque settings
| Nut | Torque (Nm) | Torque (ft/lbs) | Remarks | Source |
|---|---|---|---|---|
| Engine oil drain plug | 34 | 25 |
|
|
| Oil filter return pipe | 8 | 6 |
|
|
| Oil temperature and level sensor | 27 | 20 |
|
|
| Cylinder head bolts | 20 | 15 | Pre-tighten |
|
| Cylinder head bolts | 60 | 44 |
|
|
| Exhaust manifold nut | 10 | 7 | Pre-tighten |
|
| Exhaust manifold nut | 20 | 15 |
|
|
| Exhaust manifold stud | 6 | 4 |
|
|
| Engine support/Intermediate mounting | 60 | 44 |
|
|
| Alternator mounting bolts | 20 | 15 |
|
|
| Camshaft pulley bolts | 20 | 15 | Pre-tighten |
|
| Front brake caliper support bolts | 190 | 140 |
|
|
| Rear brake caliper support bolts | 108 | 80 |
|
|
| Front suspension lower arm to Body | 125 | 92 |
|
|
| Bottom ball joint clamp bolt-nut assembly | 70 | 52 |
|
|
| Suspension strut bolt-nut assembly | 92 | 68 |
|
|
| Power steering pump bolt | 22 | 16 |
|
|
| Stabilising bar bolt | 85 | 63 |
|
|
| Stabilising bar nut | 130 | 96 |
|
Did you find the answer to your specific question?
👍 1 👎 2
