Nissan Xterra 1 (1999-2004) Torque Spec Settings
By The original uploader was Brownings at English Wikipedia. - Transferred from en.wikipedia to Commons., CC BY-SA 3.0
Below you'll find the tightening torques for the Nissan Xterra 1 in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Nissan Xterra 1
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Transmission fluid pan | Drain plug | 25 | 18 | Minimum torque |
|
|
| Transmission fluid pan | Drain plug | 34 | 25 | Maximum torque |
|
|
| Transmission fluid pan | Drain plug | 25 | 18 | Minimum torque |
|
|
| Transmission fluid pan | Drain plug | 34 | 25 | Maximum torque |
|
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 1999 - 2004
- Generation: 1
- Type of van: car
- Model variant: Base
- Also known as:
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Sensor | Heated oxygen sensor 2 (rear) | 40 | 30 | Minimum torque |
|
|
| Sensor | Heated oxygen sensor 2 (rear) | 60 | 44 | Maximum torque |
|
|
| Sensor | Rear wheel sensor bolt | 21 | 15 | Minimum torque |
|
|
| Sensor | Rear wheel sensor bolt | 27 | 20 | Maximum torque |
|
|
| Starter | Starter motor to Transmission | 41 | 30 | Minimum torque |
|
|
| Starter | Starter motor to Transmission | 52 | 38 | Maximum torque |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Differential | Rear axle case drain plug | 59 | 44 | Minimum torque |
|
|
| Differential | Rear axle case drain plug | 98 | 72 | Maximum torque |
|
|
| Differential | Rear axle case filler plug | 59 | 44 | Minimum torque |
|
|
| Differential | Rear axle case filler plug | 98 | 72 | Maximum torque |
|
|
| Wheel hub assembly | Front wheel hub nut | 118 | 87 | Minimum torque |
|
|
| Wheel hub assembly | Front wheel hub nut | 147 | 108 | Maximum torque |
|
|
| Wheel hub assembly | Front wheel hub bolt | 49 | 36 | Minimum torque |
|
|
| Wheel hub assembly | Front wheel hub bolt | 69 | 51 | Maximum torque |
|
|
| Wheel hub assembly | Rear wheel hub nut | 118 | 87 | Minimum torque |
|
|
| Wheel hub assembly | Rear wheel hub nut | 147 | 108 | Maximum torque |
|
|
| Wheel hub assembly | Front wheel bearing lock nut | 78 | 58 | Minimum torque |
|
|
| Wheel hub assembly | Front wheel bearing lock nut | 98 | 72 | Maximum torque |
|
|
| Wheel hub assembly | Rear wheel bearing lock nut | 147 | 108 | Minimum torque |
|
|
| Wheel hub assembly | Rear wheel bearing lock nut | 196 | 145 | Maximum torque |
|
|
| Wheel hub assembly | Front auto-lock free-running hub assembly bolt | 25 | 18 | Minimum torque |
|
|
| Wheel hub assembly | Front auto-lock free-running hub assembly bolt | 34 | 25 | Maximum torque |
|
|
| Drive/Axle shaft | Rear axle shaft nut | 118 | 87 | Minimum torque |
|
|
| Drive/Axle shaft | Rear axle shaft nut | 147 | 108 | Maximum torque |
|
|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Tie rod end | Tie-rod assembly nuts | 59 | 44 | Minimum torque |
|
|
| Tie rod end | Tie-rod assembly nuts | 74 | 55 | Maximum torque |
|
|
| Tie rod end | Tie-rod assembly to Relay rod nuts | 59 | 44 | Minimum torque |
|
|
| Tie rod end | Tie-rod assembly to Relay rod nuts | 74 | 55 | Maximum torque |
|
|
| Tie rod end | Tie-rod assembly (LH) lock nuts | 78 | 58 | Minimum torque |
|
|
| Tie rod end | Tie-rod assembly (LH) lock nuts | 98 | 72 | Maximum torque |
|
|
| Pitman arm | Pitman arm to Relay rod nut | 54 | 40 | Minimum torque |
|
|
| Pitman arm | Pitman arm to Relay rod nut | 98 | 72 | Maximum torque |
|
|
| Idler arm | Idler arm nut | 54 | 40 | Minimum torque |
|
|
| Idler arm | Idler arm nut | 69 | 51 | Maximum torque |
|
|
| Idler arm | Idler arm to Swivel joint nut | 54 | 40 | Minimum torque |
|
|
| Idler arm | Idler arm to Swivel joint nut | 98 | 72 | Maximum torque |
|
|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Shock absorbers/shocks | Front shock absorber upper nut | 16 | 12 | Minimum torque |
|
|
| Shock absorbers/shocks | Front shock absorber upper nut | 22 | 16 | Maximum torque |
|
|
| Stabilizer bar | Front stabilizer bar clamp | 50 | 37 | Minimum torque |
|
|
| Stabilizer bar | Front stabilizer bar clamp | 60 | 44 | Maximum torque |
|
|
| Control arm | Front upper link assembly adjusting bolts | 98 | 72 | Minimum torque |
|
|
| Control arm | Front upper link assembly adjusting bolts | 118 | 87 | Maximum torque |
|
|
| Control arm | Front lower link assembly | 108 | 80 | Minimum torque |
|
|
| Control arm | Front lower link assembly | 142 | 105 | Maximum torque |
|
|
| Ball joint | Front upper ball joint nut | 78 | 58 | Minimum torque |
|
|
| Ball joint | Front upper ball joint nut | 147 | 108 | Maximum torque |
|
|
| Ball joint | Front lower ball joint nut | 118 | 87 | Minimum torque |
|
|
| Ball joint | Front lower ball joint nut | 191 | 141 | Maximum torque |
|
|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
IFCAR, Public domain, via Wikimedia Commons
Did you find the answer to your specific question?
👍 0 👎 0
