Chevrolet Impala Eighth (2000-2005) Torque Spec Settings
ByIFCAR - Own work, Public Domain
Below you'll find the tightening torques for the Chevrolet Impala Eighth in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Chevrolet Impala Eighth
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Steering wheel | Wheel nuts | 140 | 103 |
|
|
|
| Steering wheel | Steering wheel | 41 | 30 |
|
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2000 - 2005
- Generation: Eighth
- Type of van: car
- Model variant: Base
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Spark plugs | Spark plugs | 2 | 1 |
|
|
|
| Spark plugs | Spark plugs to new cylinder | 27 | 20 |
|
|
|
| Spark plugs | Spark plugs to existing cylinder | 15 | 11 |
|
|
|
| Throttle body | Throttle body nuts | 10 | 7 |
|
|
|
| Sensor | A/C refreigerant pressure sensor | 5 | 4 |
|
|
|
| Sensor | MAF sensor | 3 | 2 |
|
|
|
| Sensor | ECT sensor | 20 | 15 |
|
|
|
| Sensor | CKP sensor | 30 | 22 |
|
|
|
| Sensor | Knock sensor | 19 | 14 |
|
|
|
| Sensor | HO2S Sensor | 41 | 30 |
|
|
|
| Sensor | TP sensor | 2 | 1 |
|
|
|
| Sensor | MAP sensor screws | 3 | 2 |
|
|
|
| Alternator | Generator brace bolts | 50 | 37 |
|
|
|
| Alternator | Generator output BAT terminal nut | 20 | 15 |
|
|
|
| Starter | Starter solenoid S terminal nut | 2 | 1 |
|
|
|
| Battery | Battery cables nuts | 15 | 11 |
|
|
|
| Battery | Junction block bolts | 10 | 7 |
|
|
|
| Battery | Ignition coils | 5 | 4 |
|
|
|
| Camshaft | Camshaft position sensor bolt | 10 | 7 |
|
|
|
| Heater core | Heater inlet pipe adapter mounting bolt | 6 | 4 |
|
|
|
| Heater core | Heater outlet pipe adapter mounting bolt | 6 | 4 |
|
|
|
| Air conditioning | A/C compressor hose to A/C compressor | 27 | 20 |
|
|
|
| Air conditioning | A/C compressor hose to evaporator tube nut | 16 | 12 |
|
|
|
| Air conditioning | A/C compressor hose to the condenser | 16 | 12 |
|
|
|
| Air conditioning | A/C pressure sensor to evaporator line | 5 | 4 |
|
|
|
| Fuel system | Fuel rail nuts | 10 | 7 |
|
|
|
| Fuel system | Fuel filter outlet threaded fitting nut | 30 | 22 |
|
|
|
| Fuel system | Fuel filter pipe screw to the under body | 13 | 10 |
|
|
|
| Fuel system | Fuel filter pipe screws to the fuel filter pipe access panel | 3 | 2 |
|
|
|
| Fuel system | Fuel filter pipe hose clamp | 3 | 2 |
|
|
|
| Fuel system | Fuel sender access panel nuts | 10 | 7 |
|
|
|
| Fuel system | Heater inlet pipe adapter mounting bolt | 6 | 4 |
|
|
|
| Fuel system | High pressure relief valve | 8 | 6 |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Drive/Axle shaft | Drive shaft nut | 160 | 118 |
|
|
|
| Drive/Axle shaft | Transaxle mount bracket bolts | 95 | 70 |
|
|
|
| Drive/Axle shaft | Transaxle shift cable bracket | 30 | 22 |
|
|
|
| Drive/Axle shaft | Transaxle mount nuts | 47 | 35 |
|
|
|
| Drive/Axle shaft | Transaxle stud nut | 25 | 18 |
|
|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Tie rod end | Outer tie rod end nut | 30 | 22 |
|
|
|
| Tie rod end | Tie rod end jam nut | 70 | 52 |
|
|
|
| Steering rack | Steering gear cradle bolts | 80 | 59 |
|
|
|
| Steering column | Steering column opening filter panel screws | 2 | 1 |
|
|
|
| Steering wheel | Wheel nuts | 140 | 103 |
|
|
|
| Steering wheel | Steering wheel | 41 | 30 |
|
|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| EGR | EGR valve inlet adapter bolts and studs | 50 | 37 |
|
|
|
| EGR | EGR valve inlet adapter bolts to the exhaust manifold | 30 | 22 |
|
|
|
| EGR | EGR valve outlet adapter pipe to intake manifold | 30 | 22 |
|
|
|
| EGR | EGR valve outlet pipe nut to EGR valve inlet adapter pipe | 30 | 22 |
|
|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Brake pedal | Accelerator pedal bolt | 5 | 4 |
|
|
|
| Master cylinder | Master cylinder | 25 | 18 |
|
|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Stabilizer bar | Stabilizer bolts | 23 | 17 |
|
|
|
| Ball Joint | Ball joint into knuckle | 165 | 122 |
|
|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
By MercurySable99 - Own work, CC BY-SA 4.0
Did you find the answer to your specific question?
👍 1 👎 3
