Chevrolet Camaro 6 (2016-2024) Torque Spec Settings
By Kevauto - Own work, CC BY-SA 4.0
Below you'll find the tightening torques for the Chevrolet Camaro 6 in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Chevrolet Camaro 6
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil pan drain plug | 25 | 18 |
|
|
|
| Differential | Drain plug | 45 | 33 |
|
|
|
| Wheels | Wheel nuts | 190 | 140 |
|
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2016 - 2024
- Generation: 6
- Type of van: car
- Model variant: Base
- Also known as:
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil pan drain plug | 25 | 18 |
|
|
|
| Oil pan | Oil pan bolt | 25 | 18 | Short |
|
|
| Oil pan | Oil pan bolt | 12 | 9 | Long |
|
|
| Oil filter | Oil filter adapter | 30 | 22 |
|
|
|
| Oil pressure switch | Oil pressure sensor | 35 | 26 |
|
|
|
| Oil dipstick | Oil level indicator tube bracket bolt | 10 | 7 |
|
|
|
| Oil feeder | Piston oil nozzle assembly | 20 | 15 |
|
|
|
| Oil pump | Oil pump bolts | 25 | 18 |
|
|
|
| Piston rods | Connecting rod bolts | 20 | 15 | First pass |
|
|
| Cylinder head | Cylinder head bolt | 80 | 59 | First pass |
|
|
| Spark plugs | Spark plug | 15 | 11 |
|
|
|
| Spark plugs | Spark plug | 20 | 15 | New cylinder head |
|
|
| Intake manifold | Intake manifold bolt | 5 | 4 | First pass |
|
|
| Intake manifold | Intake manifold bolt | 10 | 7 | Final pass |
|
|
| Intake manifold | Intake manifold cover stud | 5 | 4 |
|
|
|
| Throttle body | Throttle body bolt | 10 | 7 |
|
|
|
| Engine block | Engine block oil gallery plug | 25 | 18 |
|
|
|
| Engine block | PCV valve | 6 | 4 |
|
|
|
| Engine mounts | Engine mount bracket fastener | 58 | 43 |
|
|
|
| Engine mounts | Engine front cover bolt | 25 | 18 |
|
|
|
| Sensor | Camshaft position sensor bolt | 25 | 18 |
|
|
|
| Sensor | Crankshaft position sensor bolt | 25 | 18 |
|
|
|
| Sensor | Knock sensor bolt | 25 | 18 |
|
|
|
| Sensor | Heated oxygen sensor (HO2S) | 41 | 30 |
|
|
|
| Sensor | Coolant temperature sensor | 20 | 15 |
|
|
|
| Battery | Ignition coil bolt | 10 | 7 |
|
|
|
| Camshaft | Camshaft retainer bolts | 15 | 11 | Torx head bolts |
|
|
| Camshaft | Camshaft position actuator solenoid valve | 65 | 48 | First pass |
|
|
| Camshaft | Camshaft position actuator magnet bolts | 10 | 7 |
|
|
|
| Crankshaft | Crankshaft bearing cap bolts - Inner | 20 | 15 | First pass |
|
|
| Crankshaft | Crankshaft bearing cap bolts - Outer | 20 | 15 | First pass |
|
|
| Crankshaft | Crankshaft balancer bolt | 330 | 243 | Used bolt |
|
|
| Crankshaft | Crankshaft balancer bolt | 150 | 111 | First pass, New bolt with flange head |
|
|
| Crankshaft | Crankshaft balancer bolt | 80 | 59 | Third pass, New bolt with flange head |
|
|
| Crankshaft | Crankshaft balancer bolt | 150 | 111 | First pass, New bolt with retained rotating washer |
|
|
| Crankshaft | Crankshaft balancer bolt | 80 | 59 | Third pass, New bolt with retained rotating washer |
|
|
| Crankshaft | Crankshaft oil deflector bolt | 10 | 7 |
|
|
|
| Crankshaft | Crankshaft rear oil seal housing bolt | 25 | 18 |
|
|
|
| Common rail | Fuel rail crossover pipe fittings | 28 | 21 |
|
|
|
| Water pump | Water pump assembly bolts | 10 | 7 |
|
|
|
| Belt tensioner/Timing chains | Accessory drive belt tensioner bolt - Lower | 22 | 16 |
|
|
|
| Belt tensioner/Timing chains | Accessory drive belt tensioner pulley bolt | 58 | 43 |
|
|
|
| PCM | Powertrain Control Module (PCM) electrical connector fasteners | 8 | 6 |
|
|
|
| PCM | Powertrain Control Module (PCM) retaining fastener | 2 | 1 |
|
|
|
| PCM | Throttle Actuator Control (TAC) module to PCM bracket | 2 | 1 |
|
|
|
| Fuel system | High pressure fuel feed pipe fittings | 28 | 21 |
|
|
|
| Fuel system | Fuel pipe assembly clip nuts | 3 | 2 |
|
|
|
| Fuel system | Fuel injection fuel rail bolt | 25 | 18 |
|
|
|
| Fuel system | Fuel pressure sensor | 33 | 24 |
|
|
|
| Fuel system | High pressure fuel pump bolts | 25 | 18 |
|
|
|
| Fuel system | Fuel tank fill and vent pipe bolts | 3 | 2 |
|
|
|
| Fuel system | Fuel tank fill hose clamp | 4 | 3 |
|
|
|
| Fuel system | Fuel tank fill pipe ground strap bolt | 8 | 6 |
|
|
|
| Fuel system | Fuel tank strap and shield bolts | 25 | 18 |
|
|
|
| Fuel system | Fuel tank shield mount bolt | 25 | 18 |
|
|
|
| Fuel system | Fuel tank shield nut | 12 | 9 |
|
|
|
| Fuel system | Fuel filter and fuel pressure regulator bracket nut | 5 | 4 |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Flywheel/Flex plate | Automatic transmission flex plate bolts | 15 | 11 | First pass |
|
|
| Flywheel/Flex plate | Automatic transmission flex plate bolts | 30 | 22 | Second pass |
|
|
| Flywheel/Flex plate | Flywheel bolts | 15 | 11 | First pass |
|
|
| Flywheel/Flex plate | Flywheel bolts | 30 | 22 | Second pass |
|
|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
By Kevauto - Own work, CC BY-SA 4.0
Did you find the answer to your specific question?
👍 0 👎 0
