Volkswagen Scirocco 3 (2008-2017) Torque Spec Settings
By Thomas doerfer- Own work, CC BY 3.0
Below you'll find the tightening torques for the Volkswagen Scirocco 3 in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Volkswagen Scirocco 3
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2008 - 2017
- Generation: 3
- Type of van: car
- Model variant: Base
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil Sump top part | 15 | 11 | First stage |
|
|
| Oil pan | Oil Sump lower part | 8 | 6 | First stage |
|
|
| Oil pump | Oil pump drive chain tensioner | 9 | 7 |
|
|
|
| Cylinder head | Cylinder head screws | 40 | 30 | Screws 1 - 10 |
|
|
| Cylinder head | Cylinder head screws | 8 | 6 | Screws 11 - 14 |
|
|
| Engine block | Balance shaft gear wheel | 10 | 7 | Coolant pump |
|
|
| Engine block | Balance shaft gear wheel | 9 | 7 | On the engine block |
|
|
| Alternator | Generator Bracket | 20 | 15 | First stage |
|
|
| Alternator | Drive chain balance shaft tensioner | 85 | 63 |
|
|
|
| Camshaft | Camshaft Adjuster | 9 | 7 | Bearing casing |
|
|
| Camshaft | Camshaft Adjuster | 9 | 7 | Cap |
|
|
| Camshaft | Camshaft Adjuster | 35 | 26 | Central Screws |
|
|
| Camshaft | Outlet camshaft wheel | 8 | 6 | M6 Central Screw |
|
|
| Camshaft | Outlet camshaft wheel | 20 | 15 | M8 Central Screw |
|
|
| Camshaft | Crankshaft central screws | 150 | 111 | First stage |
|
|
| Crankshaft | Balance shaft timing chain guide rail | 20 | 15 | Balance shaft timing chain guide rail |
|
|
| Crankshaft | Balance shaft timing chain tension rail | 20 | 15 | Balance shaft timing chain tension rail |
|
|
| Crankshaft | Bottom part of the control unit housing | 8 | 6 | Bottom part of the control unit housing |
|
|
| Crankshaft | Crankshaft sensor | 10 | 7 |
|
|
|
| Crankshaft | Main bearing | 65 | 48 | Center |
|
|
| Crankshaft | Main bearing | 20 | 15 | Lateral-fitting |
|
|
| Water pump | Cooling system - coolant pump | 9 | 7 | Gradually tighten screws crosswise |
|
|
| Air conditioning | Air-conditioning compressor bracket, M10 x 30 screws | 20 | 15 | First Stage |
|
|
| Belt tensioner/Timing chains | Auxiliary Drive belt tensioner | 10 | 7 |
|
|
|
| Belt tensioner/Timing chains | Control drive chain tensioner | 9 | 7 |
|
|
|
| Belt tensioner/Timing chains | Control chain tensioning rail | 20 | 15 |
|
|
|
| Exhaust manifold | Exhaust manifold | 30 | 22 | Bottom Nuts |
|
|
| Exhaust manifold | Exhaust manifold | 25 | 18 | Top Nuts |
|
|
| Catalytic converter | Catalytic converter | 40 | 30 | Nuts must be replaced |
|
|
| Shock absorbers/shocks | Connecting rod bearing, M8 | 30 | 22 |
|
|
|
| Shock absorbers/shocks | Connecting rod bearing, M9 | 45 | 33 |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
By Kārlis Dambrāns from Latvia - Volkswagen Scirocco 2008 67, CC BY 2.0
Did you find the answer to your specific question?
👍 0 👎 1
