Toyota Highlander XU20 (2000-2007) Torque Spec Settings
By IFCAR - Own work, Public Domain
Below you'll find the tightening torques for the Toyota Highlander XU20 in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Toyota Highlander XU20
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Wheels | Wheel nut | 103 | 76 |
|
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 2000 - 2007
- Generation: 1
- Type of van: car
- Model variant: Base
- Also known as:
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil pan drain plug to Oil pan | 25 | 18 |
|
|
|
| Oil pan | Oil pan to Stiffening crankcase assembly | 9 | 7 |
|
|
|
| Oil filter | Oil filter to Cylinder block | 18 | 13 |
|
|
|
| Oil pressure switch | Oil pressure switch to Cylinder head | 15 | 11 |
|
|
|
| Oil dipstick | Oil level gauge guide to Water by-pass pipe No.1 | 9 | 7 |
|
|
|
| Oil pump | Oil pump to Cylinder block | 19 | 14 |
|
|
|
| Oil pump | Oil pump drive sprocket to Oil pump | 30 | 22 |
|
|
|
| Oil pump | Oil pump to Oil pump cover | 9 | 7 |
|
|
|
| Oil pump | Oil pump to Oil pump strainer | 9 | 7 |
|
|
|
| Piston rods | Connecting rod cap to Connecting rod | 25 | 18 | Step 1 |
|
|
| Cylinder head | Cylinder head to Cylinder block | 79 | 58 | Step 1 |
|
|
| Cylinder head | Cylinder head cover to Cylinder head bolt | 11 | 8 | Bolt A |
|
|
| Cylinder head | Cylinder head cover to Cylinder head bolt | 14 | 10 | Bolt B |
|
|
| Cylinder head | Cylinder head cover to Cylinder head nut | 11 | 8 |
|
|
|
| Cylinder head | Ventilation valve to Cylinder head cover | 19 | 14 |
|
|
|
| Spark plugs | Spark plug to Cylinder head | 19 | 14 |
|
|
|
| Intake manifold | Intake manifold to Cylinder head sub-assembly | 30 | 22 |
|
|
|
| Intake manifold | Intake manifold sub-assembly to Cylinder head assembly | 30 | 22 |
|
|
|
| Throttle body | Throttle body assembly to Intake manifold | 30 | 22 |
|
|
|
| Engine block | Drive shaft bearing bracket to Cylinder block | 64 | 47 |
|
|
|
| Engine block | Water inlet to Cylinder block | 9 | 7 |
|
|
|
| Engine block | Balance shaft housing to Stiffening crankcase assembly | 22 | 16 | Step 1 |
|
|
| Engine block | Stiffening crankcase assembly to Cylinder block | 33 | 24 |
|
|
|
| Engine block | W/head taper screw plug No.1 to Cylinder block | 26 | 19 |
|
|
|
| Engine block | Oil control valve filter to Cylinder block | 30 | 22 |
|
|
|
| Engine block | Cylinder block water drain cock to Stiffening crankcase assembly | 25 | 18 |
|
|
|
| Engine mounts | Engine mounting bracket RH to Cylinder head | 54 | 40 |
|
|
|
| Engine mounts | Engine mounting bracket No.2 RH to Timing chain cover | 20 | 15 |
|
|
|
| Engine mounts | Engine mounting bracket RR to Transfer bolt | 34 | 25 | Bolt A |
|
|
| Engine mounts | Engine mounting bracket RR to Cylinder block | 64 | 47 | Bolt B |
|
|
| Engine mounts | Engine mounting insulator LH to Automatic transaxle assembly | 95 | 70 |
|
|
|
| Engine mounts | Engine mounting insulator RH to Engine mounting bracket RH | 95 | 70 |
|
|
|
| Engine mounts | Engine mounting insulator FR to Engine mounting bracket FR | 87 | 64 |
|
|
|
| Engine mounts | Engine mounting insulator RR to Engine mounting bracket RR | 75 | 55 |
|
|
|
| Engine mounts | Engine mounting stay No.2 RH to Engine mounting control rod bracket No.2 | 64 | 47 |
|
|
|
| Sensor | Knock sensor to Cylinder block sub-assembly | 20 | 15 |
|
|
|
| Sensor | Speed sensor front LH to Steering knuckle | 8 | 6 |
|
|
|
| Sensor | Speed sensor front RH to Steering knuckle | 8 | 6 |
|
|
|
| Sensor | Crank position sensor to Timing chain cover | 9 | 7 |
|
|
|
| Sensor | Camshaft position sensor to Cylinder head | 9 | 7 |
|
|
|
| Sensor | Heated oxygen sensor (Bank 1, sensor 2) to Exhaust pipe assembly front | 44 | 32 |
|
|
|
| Alternator | Generator assembly bracket bolt | 52 | 38 | Bolt A |
|
|
| Alternator | Generator assembly bracket bolt | 21 | 15 | Bolt B |
|
|
| Starter | Starter assembly to Automatic transaxle assembly | 39 | 29 |
|
|
|
| Battery | Ignition coil assembly to Cylinder head | 9 | 7 |
|
|
|
| Camshaft | Camshaft timing gear assembly to Camshaft | 54 | 40 |
|
|
|
| Camshaft | Camshaft timing gear or sprocket to Camshaft | 54 | 40 |
|
|
|
| Camshaft | Camshaft bearing cap No.1 to Cylinder head | 30 | 22 |
|
|
|
| Camshaft | Camshaft bearing cap No.2 to Cylinder head | 30 | 22 |
|
|
|
| Camshaft | Camshaft bearing cap No.3 to Cylinder head | 9 | 7 |
|
|
|
| Camshaft | Camshaft timing oil control valve to Cylinder head | 9 | 7 |
|
|
|
| Crankshaft | Crankshaft pulley to Crankshaft | 180 | 133 |
|
|
|
| Crankshaft | Crankshaft bearing cap to Cylinder block | 20 | 15 | Step 1 |
|
|
| Crankshaft | Crankshaft bearing cap to Cylinder block | 40 | 30 | Step 2 |
|
|
| Crankshaft | Timing chain guide to Crankshaft bearing cap No.1 | 9 | 7 |
|
|
|
| Crankshaft | Drive plate and ring gear to Crankshaft | 98 | 72 |
|
|
|
| Crankshaft | Chain vibration damper No.1 to Cylinder head | 9 | 7 |
|
|
|
| Crankshaft | Chain vibration damper No.1 to Cylinder block | 9 | 7 |
|
|
|
| Water pump | Water pump assembly to Cylinder block | 9 | 7 |
|
|
|
| Water pump | Water pump pulley to Water pump assembly | 26 | 19 |
|
|
|
| Fuel/Oil cooler | Oil cooler to Union | 79 | 58 |
|
|
|
| Fuel/Oil cooler | Oil cooler to Cylinder block | 9 | 7 |
|
|
|
| Air conditioning | Compressor and magnetic clutch to Bracket | 25 | 18 |
|
|
|
| Belt tensioner/Timing chains | V-ribbed belt tensioner assembly to Timing chain cover | 60 | 44 |
|
|
|
| Belt tensioner/Timing chains | Chain tensioner assembly to Timing chain cover | 9 | 7 |
|
|
|
| Belt tensioner/Timing chains | Chain tensioner plate to Stiffening crankcase assembly | 12 | 9 |
|
|
|
| Belt tensioner/Timing chains | Chain tensioner slipper to Cylinder block | 19 | 14 |
|
|
|
| Belt tensioner/Timing chains | Timing chain cover bolt | 9 | 7 | Bolt A |
|
|
| Belt tensioner/Timing chains | Timing chain cover bolt | 21 | 15 | Bolt B |
|
|
| Belt tensioner/Timing chains | Timing chain cover bolt | 43 | 32 | Bolt C |
|
|
| Belt tensioner/Timing chains | Timing chain cover nut | 9 | 7 |
|
|
|
| PCM | ECM to Instrument panel reinforcement | 6 | 4 |
|
|
|
| PCM | ECM to Blower assembly | 6 | 4 |
|
|
|
| Fuel system | Fuel delivery pipe to Cylinder head | 20 | 15 |
|
|
|
| Fuel system | Fuel tank band sub-assembly No.1 LH to Body | 39 | 29 |
|
|
|
| Fuel system | Fuel tank band sub-assembly No.1 RH to Body | 39 | 29 |
|
|
|
| Fuel system | Fuel tank protector to Fuel tank assembly | 6 | 4 |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Torque converter | Drive plate and ring gear to Torque converter | 41 | 30 |
|
|
|
| Transfer | Transfer fill plug | 49 | 36 |
|
|
|
| Drive/Axle shaft | Front axle hub LH nut to Front drive shaft | 294 | 217 |
|
|
|
| Drive/Axle shaft | Propeller shaft to Intermediate shaft | 74 | 55 |
|
|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Tie rod end | Tie rod assembly to Steering knuckle | 49 | 36 |
|
|
|
| Steering rack | Rack & pinion power steering gear assembly to Front frame assembly | 70 | 52 |
|
|
|
| Power steering | Vane pump assembly housing rear to Housing front | 22 | 16 |
|
|
|
| Power steering | Vane pump assembly pressure port union | 69 | 51 |
|
|
|
| Power steering | Vane pump assembly suction port union set bolt | 12 | 9 |
|
|
|
| Power steering | Vane pump assembly set bolt | 37 | 27 |
|
|
|
| Power steering | Vane pump assembly set bolt | 26 | 19 | For use without SST |
|
|
| Power steering | Vane pump assembly to Timing chain cover | 43 | 32 |
|
|
|
| Power steering | Vane pump assembly pressure feed tube assembly set union bolt | 52 | 38 |
|
|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Exhaust manifold | Exhaust pipe assembly front to Exhaust manifold converter sub-assembly | 48 | 35 |
|
|
|
| Exhaust manifold | Exhaust pipe assembly center to Exhaust pipe assembly front | 56 | 41 |
|
|
|
| Exhaust manifold | Exhaust pipe assembly tail to Exhaust pipe assembly center | 48 | 35 |
|
|
|
| Exhaust manifold | Exhaust manifold stay to Cylinder block | 44 | 32 |
|
|
|
| Exhaust manifold | Exhaust pipe assembly front to Exhaust manifold converter sub-assembly | 44 | 32 |
|
|
|
| Catalytic converter | Exhaust manifold converter sub-assembly to Cylinder head | 37 | 27 |
|
|
|
| Catalytic converter | Manifold converter insulator No.1 to Exhaust manifold converter | 12 | 9 |
|
|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Brake pedal | Accelerator pedal rod assembly to Body | 5 | 4 |
|
|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
By OSX - Own work, Public Domain
Did you find the answer to your specific question?
👍 0 👎 2
