Toyota Camry XV10 (1992-1996) Torque Spec Settings
By Jason Lawrence from New York - Toyota Camry, CC BY 2.0
Below you'll find the tightening torques for the Toyota Camry XV10 in both Nm and ft/lbs. The first table contains the most-used torque settings. The tables after it contain all torque spec values I could find.
Most-used torque specs for Toyota Camry XV10
| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil pan drain plug | 39 | 29 |
|
|
|
| Fuel/Oil cooler | Oil pan drain plug | 8 | 6 |
|
|
|
| Wheel hub assembly | Front axle hub nut | 294 | 217 |
|
|
|
| Transmission fluid pan | Drain plug | 49 | 36 |
|
|
|
| Steering wheel | Steering wheel | 35 | 26 |
|
|
|
| Wheels | Front wheel | 103 | 76 |
|
|
To make sure these are the correct tightening torque values, you can use the data below to verify this is the right model.
Are these torque settings right for you?
- Production years: 1992 - 1996
- Generation: 3
- Type of van: car
- Model variant: Base
All Torque Settings in Tables
engine torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Oil pan | Oil pan drain plug | 39 | 29 |
|
|
|
| Oil pan | Oil pan to Cylinder block | 5 | 4 |
|
|
|
| Oil filter | Oil strainer to Cylinder block | 5 | 4 |
|
|
|
| Oil pump | Oil pan to Oil pump | 5 | 4 |
|
|
|
| Oil pump | Oil strainer to Oil pump | 5 | 4 |
|
|
|
| Oil pump | Oil pump to Cylinder block | 9 | 7 |
|
|
|
| Oil pump | Oil pump pulley to Oil pump drive shaft | 28 | 21 |
|
|
|
| Oil pump | Oil pump body cover to Oil pump body | 9 | 7 |
|
|
|
| Piston rods | Connecting rod cap to Connecting rod | 25 | 18 | Stage 1 |
|
|
| Cylinder head | Cylinder head to Cylinder block | 49 | 36 | Stage 1 |
|
|
| Cylinder head | Cylinder head cover to Cylinder head | 23 | 17 |
|
|
|
| Cylinder head | Spark plug tube to Cylinder head | 39 | 29 |
|
|
|
| Cylinder head | No.1 idler pulley to Cylinder head | 42 | 31 |
|
|
|
| Cylinder head | No.1 air intake chamber stay to Cylinder head | 42 | 31 |
|
|
|
| Cylinder head | Water outlet to Cylinder head | 15 | 11 |
|
|
|
| Spark plugs | Spark plug to Cylinder head | 18 | 13 |
|
|
|
| Intake manifold | Intake manifold to Cylinder head | 19 | 14 |
|
|
|
| Intake manifold | Intake manifold stay to Intake manifold | 22 | 16 |
|
|
|
| Intake manifold | Intake manifod stay to Cylinder block | 42 | 31 |
|
|
|
| Intake manifold | No.1 air intake chamber stay to Intake manifold | 42 | 31 |
|
|
|
| Throttle body | Throttle body to Intake manifold | 19 | 14 |
|
|
|
| Engine block | Cylinder block drain plug | 13 | 10 |
|
|
|
| Engine block | Cylinder block stiffener plate | 37 | 27 |
|
|
|
| Engine block | No.2 idler pulley to Cylinder block | 42 | 31 |
|
|
|
| Engine block | Engine RH mounting bracket to Cylinder block | 28 | 21 |
|
|
|
| Engine block | No.2 engine mounting bracket to Cylinder block | 52 | 38 |
|
|
|
| Engine block | Main bearing cap to Cylinder block | 59 | 44 |
|
|
|
| Engine block | Engine balancer to Cylinder block | 49 | 36 |
|
|
|
| Engine block | Rear oil seal retainer to Cylinder block | 9 | 7 |
|
|
|
| Engine block | Rear end plate to Cylinder block | 9 | 7 |
|
|
|
| Sensor | Knock sensor to Cylinder block | 37 | 27 |
|
|
|
| Alternator | Generator to Generator bracket | 52 | 38 |
|
|
|
| Alternator | Generator to Adjusting bar | 18 | 13 |
|
|
|
| Alternator | Generator pulley to Rotor | 110 | 81 |
|
|
|
| Alternator | Generator bracket to Cylinder head | 42 | 31 |
|
|
|
| Camshaft | Camshaft timing pulley to Camshaft | 54 | 40 |
|
|
|
| Camshaft | Camshaft timing pulley to Camshaft | 37 | 27 | For use with SST |
|
|
| Camshaft | Camshaft bearing cap to Cylinder head | 19 | 14 |
|
|
|
| Crankshaft | Crankshaft pulley to Crankshaft | 108 | 80 |
|
|
|
| Crankshaft | No.1 balance shaft housing to No.2 balance shaft housing | 22 | 16 | Stage 1 |
|
|
| Water pump | Water pump to Cylinder block | 9 | 7 |
|
|
|
| Water pump | Water pump to Water pump cover | 9 | 7 |
|
|
|
| Water pump | Water bypass pipe to Water pump cover | 9 | 7 |
|
|
|
| Water pump | Water inlet to Water pump | 9 | 7 |
|
|
|
| Water pump | Water inlet to Water pump cover | 9 | 7 |
|
|
|
| Fuel/Oil cooler | Oil cooler to Cylinder block relief valve | 78 | 58 |
|
|
|
| Fuel/Oil cooler | Oil pan drain plug | 8 | 6 |
|
|
|
| Radiator | Radiator support bolt | 13 | 10 |
|
|
|
| Radiator | Radiator oil cooler to Radiator lower tank | 8 | 6 |
|
|
|
| Radiator | Radiator oil cooler pipe | 22 | 16 |
|
|
|
| Radiator | TVV to Water outlet housing | 29 | 21 |
|
|
|
| Air conditioning | A/C compressor to Cylinder block | 27 | 20 |
|
|
|
| Fuel system | Fuel line union bolt | 29 | 21 |
|
|
|
| Fuel system | Fuel line flare nut - Fuel pump side | 28 | 21 | Use SST |
|
|
| Fuel system | Fuel line flare nut | 30 | 22 | Use SST |
|
|
| Fuel system | Fuel tank band to Body | 39 | 29 |
|
|
|
| Fuel system | Fuel pump to Fuel tank | 4 | 3 |
|
|
|
| Fuel system | Fuel pressure regulator to Delivery pipe | 5 | 4 |
|
|
|
| Fuel system | Fuel return pipe to Fuel pressure regulator | 19 | 14 |
|
|
|
| Fuel system | Delivery pipe to Cylinder head | 13 | 10 |
|
|
|
| Fuel system | Fuel pulsation damper to Delivery pipe | 34 | 25 |
|
|
drivetrain torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Flywheel/Flex plate | Flywheel to Crankshaft | 88 | 65 |
|
|
|
| Transmission mount/case | Transaxle case stiffener plate | 37 | 27 |
|
|
steering torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Power steering | Power steering pump pulley to Pump shaft | 43 | 32 |
|
|
|
| Power steering | Power steering pump installation bolt | 43 | 32 | Adjusting bolt |
|
|
| Power steering | Power steering pump installation bolt | 43 | 32 | Through bolt |
|
|
| Power steering | PS pump bracket to Cylinder block | 43 | 32 |
|
|
|
| Power steering | Power steering pump to Pressure tube | 51 | 38 |
|
|
|
| Power steering | Pressure port union to Pump housing | 69 | 51 |
|
|
|
| Power steering | Suction port union to Pump housing | 13 | 10 |
|
|
exhaust torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to | |
|---|---|---|---|---|---|---|
| Exhaust manifold | WU-TWC to Exhaust manifold | 29 | 21 |
|
|
|
| Exhaust manifold | Exhaust manifold to Cylinder head | 49 | 36 |
|
|
|
| Exhaust manifold | Exhaust manifold stay to WU-TWC | 42 | 31 |
|
|
|
| Exhaust manifold | Exhaust manifold stay to FR engine mounting insulator | 42 | 31 |
|
|
|
| Exhaust manifold | No.1 exhaust manifold stay to WU-TWC | 42 | 31 |
|
|
|
| Exhaust manifold | No.1 exhaust manifold stay to Cylinder block | 42 | 31 |
|
|
|
| Exhaust manifold | Front exhaust pipe to WU-TWC | 62 | 46 |
|
|
|
| Exhaust manifold | Front exhaust pipe to Center exhaust pipe | 56 | 41 |
|
|
|
| EGR | EGR valve to Intake manifold | 13 | 10 |
|
|
|
| EGR | EGR valve to EGR pipe | 59 | 44 |
|
|
brakes torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
suspension torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
general torque settings
Save to email ✉️| Part | Description | Torque (Nm) | Torque (ft/lbs) | Remarks | Applies to |
|---|
M.rJirapat, CC BY-SA 4.0, via Wikimedia Commons
Did you find the answer to your specific question?
👍 2 👎 0
_in_Thailand_02.jpg){kind=link}